Sirius Satellite Radio SR-101C Manuel d'utilisateur télécharger pdf (Page 18)

Home Signal Distribution Kit Installation Guide

The next diagram shows the same conguration as the previous illustration.

You can see that one output of the multiswitch is connected to the input of the

Combiner, and that there are no devices such a splitter or DishPro adapter in the

common cable run between the Combiner and Splitter. If a DishPro adapter is

needed, it must be installed after the Splitter as shown.

WITHOUT DISHPRO ADAPTER: WITH DISHPRO ADAPTER:

RECVR/TUNERs

COMBINER

MULTISWITCH

RECVR/TUNERs

MULTISWITCH

SIRIUS

RECEIVER

COMMON

CABLE RUN

RECVR/TUNER

COMBINER

SPLITTER

DISHPRO

ADAPTER

SIRIUS

RECEIVER

COMMON

CABLE RUN

RECVR/TUNER

SPLITTER

Materials Required

In order to install the SIRIUS antenna and the Combiner and Splitter, you will

need to purchase several lengths of RG-6 cables to complete your installation.

The length of the cables needed is dependent upon your particular conguration.

RG-6 cable is typically sold in lengths of 10, 25, or 50 ft., with “F” type connec-

tors on each end. These cables may be purchased at your local hardware store,

home center, or electronics retailer.

The cables which must be purchased are depicted in the following illustration as

solid black and are numbered, while existing cables are shown as gray.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Pas de commentaire

Sirius Satellite Radio SR-101C Manuel d'utilisateur Page 18