Sirius Satellite Radio SR-101C Manuel d'utilisateur télécharger pdf (Page 30)

Home Signal Distribution Kit Installation Guide

Before Multiswitch Conguration Installation Procedure

Once the antenna has been mounted according to the previous instructions, you

can continue with the installation of the Combiner and Splitter:

Be sure that the satellite TV receiver/tuner is plugged into an AC outlet.

Take the RG-6 cable which you purchased to connect to the SIRIUS anten-

na and thread one end of the cable through the opening in the end of the

rubber boot. Then connect the cable to the antenna pod as shown in the

illustration following. Slide the rubber boot over the cable connection to pro-

vide a weather proof seal and install the cable tie around the cable directly

below the rubber boot to prevent the rubber boot from slipping down. Trim

off the excess cable tie. Route the remainder of the antenna cable to where

you are locating the Combiner. When routing the antenna cable, be careful

not to pinch, squash, kink, or crimp the cable, or cut, damage, or puncture

the external jacket of the antenna cable.

Connect one of the RG-6 cables you purchased from the SIRIUS antenna

to the SIRIUS RADIO port on the Combiner (SR2261) as shown. (Refer to

page 5 for the Combiner port identication.)

EXISTING

RG-6 CABLE

EXISTING

RG-6 CABLE

Combiner

Step 4

Step 5

Step 3

Step 2

Multiswitch

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 39 40

Pas de commentaire

Sirius Satellite Radio SR-101C Manuel d'utilisateur Page 30